Motor Wire Route... PN pod v2 94mm wheelbase

PN motor pod is the best pod in the market right now. So if you're still running that Atomic pod... it's time to upgrade.

A lot of the newer drivers don't really pay much attention to those motor wires hitting the body, rubbing on the tires, etc... but guess what? This scale is so small that when that motor wire hits the body, it actually causes a "tweak" feel to the car.

Where do we run the motor wire? Well, anywhere you want as long as it is not too short or too long. Too long like PN70 motor wire and installing the wires without cutting the length. Those wires is what I call, "too long". So you must shorten them. Too short would be less than an inch where you can visibly see the rear end of the car, not even or balance when looking at it from the rear. This can be caused by having a short wire that's already pulling the motor or too short that when it's soldered to the board and the motor, you can see the kink on the motor wire pushing the rear pod on one side. This too is too short. What you want is to have the motor wire away from the disc plate, top shocks, wheels and differential shaft.

This is how I run my motor wire. (+ positive side wire is a bit long but that's because this car was a 98mm setup before...)

Thanks for reading!